CoatLiner 1050H

Typical Application Environments

SealBoss CoatLiner Pro is recommended for use as a coating or lining on suitably primed carbon steel, non-ferrous metal and concrete for use in:

• Petrochemical Plants
• Pipe Lining and Repair
• Pulp and Paper Plants
• Concrete Storage Tanks
• Secondary Containment
• Water / Wastewater Treatment Plants
• Mining
• Power Plants
• Man Holes

Installation Guidelines

SealBoss CoatLiner Pro may not be diluted under any circumstances. Use appropriate solvent for solvent purge line and flushing of equipment and if spraying stops for periods exceeding the potlife of the material. Thoroughly mix each CoatLiner Pro Side Base material with air driven power equipment until a homogeneous mixture and color is obtained. Side-B Base material must be thoroughly agitated for at least thirty (30) minutes prior to application. Total suspension must be achieved. Opened material must be used within 1-2 days due to moisture sensitivity.

Apply over prepared and suitably primed carbon steel or concrete. Surface Preparation Method; Carbon Steel: SSSP-SP-10, 5 or SP-12 (WJ-4) Concrete. Sandblast or Grit Blast to provide a 2-3 mil anchor profile.

Application temperature for CoatLiner Pro should be between 60-100F with relative humidity of 0-50%. Do not apply product unless temperature is at least 5F above the dewpoint. Recoat schedule is 1-3 hours dependent upon environment. See Specification Guide for recoating guidelines and additional information. Check area of application to ensure that it conforms to the substrate requirements, as stated in Section 3.04 of the Engineering Specifications. Prime with the appropriate primer. See Engineering Specification Section 4 for more information on specific primers and their associated applications. Use Airless equipment or equal designed for heated, plural component, high pressure spray application. High pressure equipment should have the capacity to apply product to a maximum 2500 psi from the proportioner to meet job site conditions. Heat and maintain material temperature in a range of 95-110°F and utilize insulated material hoses and application equipment to ensure spray consistency, metering and degree of cure of properly mixed product. Band heaters should not be used to heat or maintain temperature. The conditioned materials shall be supplied to the proportioning equipment at a flowable, pumpable viscosity, and in such volume delivery to assure full supply for each pump stroke.